

0%
WSB42 G2
- Where to use
- Features
- Download
The WSB42X Module provides all the functionality of the WSB42. Additional features have been added including Wheatstone bridge current-excitation, dynamic strain mode, ICP® sensor support and a higher sampling rate.
- With any strain gauge in quarter, half and full bridge, load cell and pressure transducer
- Inductive displacement transducer (LVDT)
- With any voltage source up to ±10 V in voltage input mode
- Current-excited bridge modes
- Measurement of dynamic strains with 2 wires
- ICP® sensors
- 4 channels
- 7 modes of operation:
- Analog input mode
- ICP® mode with 4, 8 or 12 mA constant current at ±12 V excitation
- Bridge voltage-excitation mode: 0-6 V (AC or DC) for >120 Ω bridges and 0-4 V for 120 Ω full bridges
- Bridge voltage-excitation mode: 8-10 V (DC) for 1 kΩ bridges
- Bridge current-excitation mode: 4, 8 or 12 mA (DC)
- 2 wire current-excitation dynamic strain mode: 4, 8 or 12 mA (DC)
- LVDT inductive displacement transducer mode (AC)
- Supports TEDS IEEE 1451.4 V0.9, V1.0 (Class 1 and 2)
- 24-bit resolution, 204.8 kSa/s sampling rate per channel, 90 kHz bandwidth
- <0.2° @ 10 kHz phase accuracy between channels of the same or any other Module
- ±(10 V, 1 V, 100 mV, 10 mV) input ranges for all modes
- 0 to 10 kHz AC excitation
- Balanced differential signal input, differential voltage-excitation output and balanced sense input
- Full, half and quarter bridge configurations
- Internal half and quarter bridge completion resistors for 120 Ω and 350 Ω bridge elements
- Local and remote sense options
- 100 kΩ internal shunt calibration resistor
- Pre and post filter overflow monitoring
- Selectable low and high pass digital filters
- Lemo 7-way EHG.0B connectors
- Broschüre: PAK MKII Hardware
- Film: The PAK MKII Frontend