

0%
ICP42 G2
- Where to use
- Features
- Download
The ICP42 G2 Module can be used with ICP® based accelerometers, force and pressure sensors as well as to measure analog voltages. All 4 channels operate independently of each other, each with their own setting of mode, gain and coupling.
- With any ICP® based sensor commonly used to measure vibration, acceleration, force or pressure
- With any voltage source up to ±10 V in voltage input mode
- 4 channels
- 2 input modes of operation:
- ICP® mode with 4 mA constant current at ±12 V or 24 V excitation
- Voltage input mode with AC or DC coupling
- Supports TEDS IEEE 1451.4 V0.9, V1.0 (Class 1)
- 24-bit resolution, 102.4 kSa/s sampling rate per channel, 45 kHz bandwidth
- <0.2° @ 10 kHz phase accuracy between channels of the same or any other Module
- ±(10 V, 1 V and 100 mV) input ranges
- There are 3 distinctive input mode options for both ICP® and voltage input modes:
- Differential or Balanced Float (ICP® mode provides ±12 V excitation)
- Single-Ended or Unbalanced Float (ICP® mode provides 24 V excitation)
- Single-Ended or Unbalanced Ground (ICP® mode provides 24 V excitation)
- Short and open circuit cable monitoring
- Signal integrity circuit continuously monitors the input and disconnects sensitive circuits during overload conditions
- Pre and post filter overflow monitoring
- Selectable low and high pass digital filters
- 2 MΩ differential and 1 MΩ single-ended input impedance
- SMB connectors
- Broschüre: PAK MKII Hardware
- Film: The PAK MKII Frontend